2nd Chance Camaro - Let the Project Begin

[syborg tt]

I needed connect the fuel level wire to the Holley ECU and of course I forget to run the wire down the passenger
side of the car. I did however run it down the drivers side but Holley wire I needed was on the passenger
side. So, now i have to neatly behind the Vintage Air Unit. Which turned out to be a major pain the backside.



I of course wrapped the shifter brackets with a towel as they are sharp as can be.



See those gray wires they are being relocated to the drivers side of the car.











Temporarily connected

[syborg tt]

I finally pulled the trigger and ordered one of these

[syborg tt]

I purchased the Anvil Radiator cover and I needed to add a couple Rivnuts to the outside two holes.

[syborg tt]

I finally installed the Gates PowerGrip hose clamps on the heater hoses.



















Eventually, I will install the Gates clamps on the Water Pump

[WSSix]

Coming along nicely, Marty!