70 Camaro - Boise, Idaho

[Goosesdad]

Thanks guys!!!

[Goosesdad]

This is the plug for the panel below the steering column.


The plug smoothed and primed with plastic hot-glued in place for a flange in the 2 piece mold.


The mold completed, with the plug still in it.


Same, other side.


Breaking out the plug from the mold.


All broken apart.


Mold cleaned and ready to laminate the part.


Yes, lots of work for a one time use mold...for a part that is getting covered and will basically be hidden from view.

[jarhead]

I would pay admission just to watch and learn. Awesome stuff!

[Cramer4918]

Originally Posted by jarhead

I would pay admission just to watch and learn. Awesome stuff!

I'm there with you. A lot of skill and knowledge being displayed.

[Goosesdad]

Thanks gents! Honestly, no voodoo here - glass is easy stuff for the talent in this group!

Laminated.


Here the part out of the mold.

[dmc69]

Amazing craftsmanship! You are an artist! I can't wait to see the interior finished.

[Rallycamaro]

Man, finished reading through the end of August on pg. 66 I think. When I went out of the thread it now only shows 3 pages and stops in June. Weirdness going on here.

Great build. I can't believe you've stuck it out this long. Patience of a saint to build it over 10 years. But, then again, that's also why it's so nice.

[camcojb]

Originally Posted by Rallycamaro

Man, finished reading through the end of August on pg. 66 I think. When I went out of the thread it now only shows 3 pages and stops in June. Weirdness going on here.

You might try logging out of the site, clearing cookies, and re-log in.

[Goosesdad]

Set the engine and trans in this weekend. Not permanent, have some details to work out with the dry sump and the headers. It was pretty satisfying for sure!!

[camcojb]

Looks incredible.