2nd Chance Camaro - Let the Project Begin

[syborg tt]

Hi Donny,

All of the bolts are tight and the brackets can't swivel. However, since the brackets are so close together I need to put a
washer behind one of them so the brackets can be flat. In the rare occasion that I have a passenger in the back seat I was
worried about them bumping the bracket. On a side note you will have to be one hell of a contortionist to get back there.


Here is a side shot of what it looks like and I am open to your advice as I this is all new to me.

Originally Posted by dontlifttoshift

What is happening here? Are those bolts tight and the belts can't swivel?




Couple of observations, I can't see your car from here but based on this picture.....

I think the harness bar is backwards. What you have as the front should be the rear. That would allow the belts to point up from the bracket and wrap over the top of the bar to the seat. As it is now, if you ever needed those shoulder harnesses, the seat belt loops themselves are just going to fold up.

If mounted the way I described they would be loaded in tension.