Dead Cat 2.0: Jake'sTorque Arm Install

[Rybar]

That looks SICK!!

[Al Moreno]

That looks AWESOME! What a difference wheels and tires make.

[cencalc6]

Awsome Job!

[coolwelder62]

I am not going to say Great job,Awesome,or looks good.Because some folks are getting tried of hearing those things.So all I will say is Can't wait to hook up W/U in Charotte this fall.

[Payton King]

I am diggin' it a pretty good bit.

Scott, at the rate I am going it may fall before I am driving. LOL Hopefully it will be on the ground by next friday. Still waiting on exhaust from coaters.

[BBC71Nova]

Fantabulous! I think that one hasn't been worn out yet and is still available for use . Hoping maybe when I come back up that way I can check out the finished product.

[Rick D]

Hay Payton, I know you said your rear end is set up to run stock size Corvette wheels, so if I could ask want width is your rear?? I am looking at doing the same thing with my 69 Camaro also what sub frame are you using?? Thanks for the info.

[Cris@JCG]

I want to see it on the ground! Looks great

[Payton King]

the width is extremely close to a stock 69. 59 inches and I am running small spacers on each side to dial in the exact spacing (1/4 to 1/2). I can get the the measurement of my spacers this week for a total width. Rims are 19x12.5 with a +53 mm offset.

I want to see it on the ground as well

[user667]

Very, very nice!