HARROP 122 HH super charger

[vette4beater]

Originally Posted by coolwelder62

THE EDDIE MOTORSPORTS FRONT DRIVE IS OVER AN 1.5 AHEAD OF THE HAROPP SET.HAROPP DOES NOT MAKE A PULLEY THAT FAR OUT IN FRONT. I WILL NOT CHANGE MY FRT DRIVE,SO I CAN NOT USE THIS BLOWER.

RIGHT!!
that was the question I was asking! If the Eddie pulley is 1.5'' further away from the block, than the F-body style harrop, then that would put it around the same spacing as the TRUCK style supercharger I have.....Making it possible for YOU to use the one that I have!

all that would be needed is a little research as to the spacing of your crank pulley. It may be the same spacing as the LS Trucks which is also the same as the 2010 and newer Camaros.

[vette4beater]

Just to MAKE SURE I am perfectly clear. I was trying to figure out if we would be able to set-up some kind of trade so you would get a supercharger that would work on your current set-up.

My Magnacharger MP112 Chevy LS Truck version for your Harrop.

[coolwelder62]

Originally Posted by vette4beater

Just to MAKE SURE I am perfectly clear. I was trying to figure out if we would be able to set-up some kind of trade so you would get a supercharger that would work on your current set-up.

My Magnacharger MP112 Chevy LS Truck version for your Harrop.

I have all ready put the EFI intake and fuel back on the engine.
so at this point I want to sell it,instead of trading it.Thanks anyway.

[coolwelder62]

Sold!!!!!!!