Hey guys bit of progress this week. Inside is pretty much sorted just need to do some more work under the dash mounting things. Console was continued through to the rear seats.
Today i made a start on fitting up the front sheet metal so we can start all the front end fab now doing the radiator support and inner fenders.
Thanks Craig
__________________
BMV Engineering, Queensland Australia
Kcrain - The bread van is about a month off being done we had a pretty major hold up on the diff and gearbox. The Chassis is a shortened C30 item with a 4link rear. It has Air bags all round. The engine is a 426 Hemi blown it has just under a 1000hp on pump gas and has 960ftp of torque. Dual 4" exhaust too. The wheels are custom made Alcos 22". Also set up power steer and aircon. The owner is keeping the patina look. It will be a family cruiser and tow car for his drag car. Might only do that a couple times as the fuel bill will be quite large.
__________________
BMV Engineering, Queensland Australia
So 2 weeks ago the owner of the Valiant told us he wanted to take it to the states largest car show as a almost complete project car so with many long days we got it there so here are some updates.
We ran tubes in the chassis rails under the floor for the fuel and wiring for the pump. These will exit out behind the rear bar and be hidden all the way the the motor.
Exhaust has been run. Dual 3.5" over the diff. Sill has also been reshaped and now wrap under to the rails.
__________________
BMV Engineering, Queensland Australia
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
It's like a ball of yarn unwinding, that has no end... Author DKz Garage
Hybrid Mode
