I'm not a metallurgist - but allowing for only .001" growth in axle length (figuring 20+ inches?) certainly doesn't allow for much heat expansion.
I do have the c-clip setup still in, so the length in question is actually the ~0.5" between the c-clip seat and the end of the axle (what the center spacer pins up against).. axle tube bearings just support the axles radially.. i was more thinking of trying to remove as much axial play as possible without adding axial preload to the c-clips...
I do have the c-clip setup still in, so the length in question is actually the ~0.5" between the c-clip seat and the end of the axle (what the center spacer pins up against).. axle tube bearings just support the axles radially.. i was more thinking of trying to remove as much axial play as possible without adding axial preload to the c-clips...
I've stayed out of this floater conversation because I just am not knowledgable on suspension or rear ends... So as long as you've thought thru the clearances -- which appears you have ('cause I certainly don't know anything about them)... then good!
REALLY......................... You can confirm that from first hand experiance can you??? or is that just what everyone has told you lmao
You were here last year--pretty sure you saw my hands on experience---lol. Thank you again for the delivery of the parts---please feel free to have an extra taco on Cris. Let's install the parts that Saturday night for fun. What could be more fun than that.