Two Dyno days one winner - Page 22 - Lateral-g Forums

Vegas69 · #**211** 01-29-2013, 11:44 PM

Agreed, Chris' engine fits his personality perfectly. They like to tinker and adjusting valves is a good father/son project.

**FETorino** · #**212** 01-29-2013, 11:50 PM

Quote:

Originally Posted by Vegas69

Some of us back up our big mouths.

Time will tell in your case.

Only a Ford owner would put cast iron heads on an aluminum block.....

Well it's a dyno thread so as soon as you actually build something better feel free to post.

**Sieg** · #**213** 01-29-2013, 11:53 PM

Quote:

Originally Posted by FETorino

So it was the car

All these decades I thought it was me

Bring back some memories

**FETorino** · #**214** 01-29-2013, 11:58 PM

Quote:

Originally Posted by Sieg

Bring back some memories

You

you

Win

**FETorino** · #**215** 02-10-2013, 10:09 PM

I have a dumb idea about running my motor on a different fuel.

I know it is a dumb idea because it is DG's idea.

Really something Dave came up with?

Yes I am running with one of his ideas

Despite knowing better I am going back to the dyno with some different pump gas the first week of March.

There is the smallest of chances DG may actually dyno his motor that same month. I doubt it but anything is possible.

**Flash68** · #**216** 02-11-2013, 11:51 AM

I don't blame ya for wanting to close the gap a little bit. I'd hate to get beat by a 100+ in this contest too.

**FETorino** · #**217** 02-11-2013, 10:09 PM

Quote:

Originally Posted by Flash68

I don't blame ya for wanting to close the gap a little bit. I'd hate to get beat by a 100+ in this contest too.

Oh your machinist bill will easily beat me by $100+ before that thing ever runs .... no chance of me closing that gap.

**Flash68** · #**218** 03-03-2013, 11:52 PM

Is this thread dead or what?

I heard that big cube FE was going for a "do over" since someone wasn't happy with the numbers first time around.

**FETorino** · #**219** 03-03-2013, 11:56 PM

Quote:

Originally Posted by Flash68

Is this thread dead or what?

I heard that big cube FE was going for a "do over" since someone wasn't happy with the numbers first time around.

DG wouldn't you be the one with the "do over" motor

My FE is going back on the dyno tomorrow. The starter on the dyno took a crap last time so I didn't get to fully test the 4150 carb that was built for the motor. Then I lost my mind and bought into some knuckleheads alternative fuel idea.

So tomorrow it goes on the dyno for a baseline run with my 1050 then some tuning runs with the 4150 on gas.

Then a few runs with the new carb on E85. I couldn't make it for this session.

intocarss · #**220** 03-04-2013, 12:05 AM