This is MY 67 Camaro

[Sonar Chief]

Originally Posted by coolwelder62

I know its in the thread somewhere but what are you using to clean everything up.Great job.

I am using my trusted DeWalt drill and a fiber disc (from Harbor Freight) and assorted wire wheels, I use my air grinder sometimes with coarse roloc discs. Just takes time to see it through .... so I get started on a piece and keep going til it's done!
Thanks for looking

[Spiffav8]

Chief you do awesome work! Very impressive.

Hey if you think it's hot up there in Colorado, come on down to Las Vegas for a few.

[Cole]

Originally Posted by Spiffav8

Chief you do awesome work! Very impressive.

Hey if you think it's hot up there in Colorado, come on down to Las Vegas for a few.

True that...

[Sonar Chief]

Originally Posted by Spiffav8

Chief you do awesome work! Very impressive.

Hey if you think it's hot up there in Colorado, come on down to Las Vegas for a few.

Yeah .... no thanks, but for Colorado weather to be in the 100's already that is way too early.

Thanks for the compliments.

[waynieZ]

Chief they're looking great..

[coolwelder62]

Originally Posted by Sonar Chief

I am using my trusted DeWalt drill and a fiber disc (from Harbor Freight) and assorted wire wheels, I use my air grinder sometimes with coarse roloc discs. Just takes time to see it through .... so I get started on a piece and keep going til it's done!
Thanks for looking

Thank's,I need to clean the bottom of my 66 Chevelle like this so I can rhino line it.

[Sonar Chief]

Originally Posted by waynieZ

Chief they're looking great..

Thanks for the words ... they mean a lot coming from you.

I had a moment last nite, I said the paint on the doors was being a bugger to get off cuz it was lacquer ... DUHHHHH, I used some lacquer thinner and got the paint broken down enough to disc off. One door done and one more to go .... that's my goal today.

Thanks for looking .... more to come

[Sonar Chief]

Originally Posted by coolwelder62

Thank's,I need to clean the bottom of my 66 Chevelle like this so I can rhino line it.

Good luck with the pan ... keep going and then you are done

[Sonar Chief]

More work on the door passenger door is almost done.

The door had more lacquer paint than the drivers cuz the repair they did ... and the paint is a bugger to get off, heats up way too quick with a disc


Almost ready for epoxy primer

Still need to get this end clean.

Ran outa steam tonight .... I'll finish tomorrow and get some epoxy on the doors this week, that's the plan anyway

[waynieZ]

Your doing a nice job on them..