New Project 72 Camaro Coolwelder62 - Page 4 - Lateral-g Forums

coolwelder62 · #31 05-18-2009, 04:49 PM

I too built a jig to make sure both sides were the same. The first test show no signs of bump steer.

Kendall Burleson · #32 05-19-2009, 12:17 AM

Good job on the frame I like the way you used the adj mount for the shock.

city_ofthe_south · #33 05-19-2009, 01:26 PM

"I have a feeling that will get some folks bagging on me."

Some folks love the phrase "the right way" .... there is no right way to have someone else build your car. Good lookin stuff.

Cris@JCG · #34 09-21-2010, 05:43 PM

Any status on this build Scott??

coolwelder62 · #35 09-21-2010, 07:13 PM

Cris this car was sold to MR.Jody Bernard back in feb.of this year.Then I was working on a 66 2 dr.sedan nova when I sold it,now I have a 72 camaro that is just like the one I sold to MR. Jody Bernard.Cris I went email you some photo's today but I must have used the wrong email because it came back undelivered.will try again tomorrow.My new camaro has the same c6 frt. sub frame w/ a 4 link that uses poly bushing in the frt. and johnny joints at the rear end side w/ panard bar.I cant get my photo's to resize or I would share w/you.

Cris@JCG · #36 09-21-2010, 07:18 PM

Gottcha! email address is [email protected]

Quote:

Originally Posted by coolwelder62

Cris this car was sold to MR.Jody Bernard back in feb.of this year.Then I was working on a 66 2 dr.sedan nova when I sold it,now I have a 72 camaro that is just like the one I sold to MR. Jody Bernard.Cris I went email you some photo's today but I must have used the wrong email because it came back undelivered.will try again tomorrow.My new camaro has the same c6 frt. sub frame w/ a 4 link that uses poly bushing in the frt. and johnny joints at the rear end side w/ panard bar.I cant get my photo's to resize or I would share w/you.