DSE Quadra link install - Lateral-g Forums

**camcojb** · #1 09-08-2014, 05:52 PM

Here's a quick write up that Scott did when he installed a Quadralink on his 69 Camaro.

DSE Quadralink install

**Revved** · #2 02-02-2015, 11:38 AM

Great Writeup!

I will throw out a great plug for DSE... They include great installation videos with their products as well. I put an Alumaframe and rear deep tub kit in the current 67 Mustang build and found their videos very helpful!

l2azorback · #3 07-14-2016, 11:07 AM

Very Nice write up! Thanks

**MillerBuilt** · #4 08-13-2016, 11:27 PM

I know everyone has their method, but I highly advise against welding on the suspension brackets after the housing ends have already been installed.

At minimal an alignment bar and applicable fixture blocks/pucks should be used while welding the suspension brackets. This will keep movement to a minimum at the housing end.

Ideally, the suspension brackets would be welded on first, then the housing ends for a perfect installation.

Hope this is helpful in addition to the above nice write-up.

Jay

speed_m5 · #5 06-10-2017, 02:06 PM

Thanks for the write up