Stainless fittings?

[69hugger]

Help!

I am looking for a stainless fitting for my proportioning valve. Inverted flare (3/8-24) to 1/8" NPT.

Like this.... only stainless.


I have tried Summit, Jegs, SSBC, Inline Tube, Classic Tube, Grainger, and a few internet sources.

Anybody know where I can find them?


Thanks,

Bill

[GregWeld]

Bill --- Check with Mark at Bent...



http://www.bentcustomandperformance.com/

[69hugger]

Thanks Greg. I was hoping he'd see this & weigh in. I didn't want to bother him over a $5 part.....


Bill

[66fury]

I would like to know what you find . I searched high and low for stainless brake fittings awhile back and it was tough. I found them in aluminum from wilwood i believe. There must be a reason they arent easily found

[69hugger]

Originally Posted by 66fury

I would like to know what you find . I searched high and low for stainless brake fittings awhile back and it was tough. I found them in aluminum from wilwood i believe. There must be a reason they arent easily found

Of course there is. It's because I NEED (want) them!

I have found about every brake fitting you can imagine in stainless EXCEPT this one.

Oh well, that's HOT RODDING!


Bill

[will69camaro]

Can you find me a Tee that's 1/8" NPT male to two 1/8" NPT female in stainless? All i can find is NOS brass one. Need it for oil feed for turbo/sensor placement on my new Mast pan...

This is the brass fitting i want in stainless...

http://www.summitracing.com/parts/nos-16775nos

William

[GregWeld]

If you were REAL car guys you'd MAKE your fittings.... "built not bought" --- LOL



Oh my..... here we go! HAHAHAHAHAHAHAHHA

[will69camaro]

I'll be a fake car guy. I've made stuff like that while in school. I'll pay the $15 for it and let someone else have that fun.

[GregWeld]

Originally Posted by will69camaro

I'll be a fake car guy. I've made stuff like that while in school. I'll pay the $15 for it and let someone else have that fun.

I'm right there with ya!

[raustinss]

And here is Greg stirring the sh*t pot