hydraulic clutch lines - Lateral-g Forums

11-10-2011, 08:21 PM

usa-69z

Senior Member

Join Date: Feb 2009

Posts: 277

Thanks: 0

Thanked 0 Times in 0 Posts

hydraulic clutch lines

Was thinkin has anyone made there own clutch to master lines using the teflon braid ?
I did make all my fuel lines using the telfon braid for my injection and wondered is there any difference in pressures for clutch rather than fuel ? and will the anodized ends be ok with these type of fluids etc?
As my car is a RHD 69 camaro i need a longer piece from master to the hydraulic throwout bearing.

thanx , Gav

__________________
69 CAMARO - RIGHT HAND DRIVE AUSSIE MODEL.
383 SBC 8 STACK INJECTED EFI.
RIDETECH FOUR LINK REAR - DSE MINI TUBS .
SPEEDTECH FRONT A ARMS & COILOVERS.
MOSER 3.7 REAR- 6 SPEED T56 TREMEC.
FIKSE RIMS ETC ETC..

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -7. The time now is 07:13 AM.