ricks stainless fuel tank & phantom fuel system - Lateral-g Forums

Buddy z/28 · #1 02-05-2014, 11:39 AM

Has anyone installed the new areomotive phantom stealth fuel system 340 .In a rick's (rockvalley) stainless steel fuel tank? I know they make a efi fuel tank,but I ordered a crate ls2 engine from pace performance .It has a victor jr.carb.manifold and a 800cfm edelbrock car. But with the new holley termantor efi system,i want to go with I need to install aeromotive phantom stealth fuel system in this tank that is set up for a carb system.I don't know were the baffle are in rick,tank are. thanks for any help buddy

s

Blake Foster · #2 02-05-2014, 01:14 PM

it might be me but this is a very confusing post. do you have a ricks tank or an Aeromotive tank the Rockvalley makes?

wiedemab · #3 02-05-2014, 02:20 PM

Quote:

Originally Posted by Blake Foster

it might be me but this is a very confusing post. do you have a ricks tank or an Aeromotive tank the Rockvalley makes?

Not just you - -I couldn't figure it out either.

Buddy z/28 · #4 02-05-2014, 05:36 PM

Sorry about the confusion. the fuel tank is the one Detroit speed sells.The narrowed fuel tank.Its for a 1969 Camaro .made by rick's. for Detroit speed What I am trying to do is install the phantom 340 fuelpump system in the tank. But I don't know were the baffle are in the tank. I don't want to cut into the tank and hit the baffles. So I was trying to find out if anyone has install this system in this tank.I want to change from a carb system to the new holley terminator efi.That is why I want to install this fuel system thanks

dontlifttoshift · #5 02-05-2014, 06:24 PM

You don't have a Ricks tank. You have a DSE tank manufactured by Rock Valley.

If you look closely at the tank you will see ripples on the top and/or bottom of the tank where there are spot welds. Those are holding the the baffles in place. You could remove the sending unit and look in with a flash light to get a better idea.

For the most part, centered side to side, towards the front would be a good location for that setup if that is what you want to run.

Buddy z/28 · #6 02-05-2014, 07:30 PM

Thanks I would have never thought of that. great idea thanks again you guy's are the best. buddy