Ats Spindle Pre Orders

[redfire69]

Originally Posted by killer69

well first off on the DSE sub that runs the factory C6 spindle/hub and ours are not compatable. the DSE sub is designed arround the c6 spindle, our spindle is designed arround the First gen sub. so neither are interchangable.
as for the ZR1 stuff, it is a little early to know if the brakes are compatable. they obviously work on Jackass. Mark would be the expert on this topic
i do know that our spindles are NOT compatable with the ZO6 hubs. the hub casting on the ZO6 is larger ( i will assume ) the bearing inside is larger. and will not clear the lower stud mount.

Sorry this is off topic, but Mario, you'll have to post up your findings on the ZR1 brakes!

[DOOM]

Originally Posted by redfire69

Sorry this is off topic, but Mario, you'll have to post up your findings on the ZR1 brakes!

Ron,I plan on talking to Mark and Charley very soon. I told Mark I would have alot of questions about this setup .... So I'll start a new thread soon!!