Narrowing a Rear End - Cost & Tooling

12-02-2010, 08:56 PM

The WidowMaker The WidowMaker is offline

Senior Member

Join Date: Jan 2008

Location: Huntington Beach, Ca

Posts: 773

Thanks: 0

Thanked 0 Times in 0 Posts

i had the 12 bolt narrowed with 9" ends, straightened, blasted, gears assembled and custom axles and bearings made for under 1k from currie. the axles were about 450 by themselves and the gear assembly was 100 so just the narrowing wasnt too bad.

__________________
"The WidowMaker"
70 Chevelle Pro Touring - Garage Built, Backyard Painted
Custom 4 Link & Watts, Rushforth Wheels, Ats Spindles, McLeod RXT Twin Clutch, T56 Magnum, C6Z Calipers & Ring Bros Hinges
Special Thanks To: Rushforth Wheels ; Kore3 ; SC&C
Build Thread : https://lateral-g.net/forums/show...ght=widowmaker

Last edited by The WidowMaker; 12-02-2010 at 09:02 PM.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 10:24 AM.