70 Camaro - Boise, Idaho

[ma73z]

Not sure how I missed this build, seriously awesome work! I wish I had your sheetmetal skills. Please keep the pics coming.

[Spiffav8]

Originally Posted by ma73z

Not sure how I missed this build, seriously awesome work! I wish I had your sheetmetal skills. Please keep the pics coming.

Yeah this is an awesome build to watch.

[Goosesdad]

Originally Posted by ma73z

Not sure how I missed this build, seriously awesome work! I wish I had your sheetmetal skills. Please keep the pics coming.

Originally Posted by Spiffav8

Yeah this is an awesome build to watch.

Thanks gents!!

[Goosesdad]

Combined the install of a 2.5 gallon oil tank with finishing the fab of the extended rocker panel. Thanks to many here...Steve, JJ, Tim McGilton and others for the concept and advice!

Used a 1" tube through the rocker to provide access for a bolt to attach the front fender. Even though I've done everything I can to eliminate any water from getting down here, I still prepped the metal to withstand the elements.

These access holes will be covered by a splitter...coming later.


Had to push the tank into the interior just a bit.



Sealed off the rocker.

Sealed off the interior.

Will have to relocate the filler and install a site tube. Prepped for this but will wait until I'm routing the oil lines.

[Goosesdad]

Test fitting the Fesler flush glass. Fits well!

[grendel]

Originally Posted by Goosesdad

Test fitting the Fesler flush glass. Fits well!
Attachment 64079

Let me know how that goes. I am still tempted.

[gofastwclass]

The rockers and oil tank mount are fantastic.

[Goosesdad]

Originally Posted by grendel

Let me know how that goes. I am still tempted.

The front fit was virtually perfect. Certainly no metal work needed, just a little filler will be necessary...a very little. My passenger door and fender sit a little lower than the driver side, in relation to the A pillar and this they expose the bottom edge if the glass. Ill post a picture. Once I finish fitting the fenders and the hood, I can decide if I will extend them to better cover the area. The glass is good. Will be a month or so until I get to fitting the rear.

[Goosesdad]

Originally Posted by waynieZ

Beautiful work! Just finding room for alll these parts amazes me. I always love comming back to check out what’s new.

Originally Posted by WSSix

Very nice as always, John. The little details are amazing and extensive in order to make this all work out properly. Keep up the good work.

Originally Posted by gofastwclass

The rockers and oil tank mount are fantastic.

Thank you!!!