Machined Stainless Steel hardware from Ring Brothers - Lateral-g Forums

**Steve1968LS2** · #1 02-04-2008, 07:51 AM

That's a lot like what I use except the washers are "deeper". Very nice. What do the back sides look like?

The perfect design would have a small raised disc on the back to help paint deformation remain unseen. Mine are flat on the back.

Also, what is the rough cost per a washer?

They sure make sweet stuff.

James OLC · #2 02-04-2008, 08:28 AM

The washers are flat on the back. All told, the total height, washer plus bolt is about the same as a standard button head.

Bill Meyer · #3 02-14-2008, 08:13 AM

I just received my order from Ring brothers for my fasteners and the pictures posted here do not do them justice. Can't believe show sharp they actually look! Fantastic! I know when I need something else I will be calling them for hood hinges, or anything else I can afford or hide from my wife

Musclerodz · #4 02-14-2008, 08:37 AM

Ordered a set hinges and bolts for a customer this week. Hopefully he will chime in. They are some nice pieces.

Mike

BobB66SS · #5 03-04-2008, 09:41 AM

Just put these on my Chevelle, what spectacular stuff. Ran mine over a polishing wheel just to add to the effect. Amazing what a difference these can make. Not inexpensive but too cool to pass up.

bigtyme1 · #6 10-08-2008, 05:08 PM

Scott, are most of the bolts under hood 5/16 or 1/4? I'm going to place my order soon

**XcYZ** · #7 10-08-2008, 05:37 PM

Most are 5/16. The larger hardware, like the bolts at the fender/firewall, are 3/8.

bigtyme1 · #8 10-08-2008, 05:42 PM

Quote:

Originally Posted by XcYZ

Most are 5/16. The larger hardware, like the bolts at the fender/firewall, are 3/8.

Thanks Scott, see you soon

**XcYZ** · #9 10-10-2008, 10:14 AM

Just an FYI, Ring Brothers increased the washer diameter on the 3/8" bolts so that the washer will cover the entire slot/hole in the fender.