My Cuda Project Part II...now at Bruning Auto Design

[DRJDVM's '69]

After much back and forth with with Rodger at Ironworks (thanks again) and Procharger, I was able to get a procharger bracket for the 6.1 HEMI, so I could make sure the inner fender design would allow a unit to fit. However it looks like the Procharger might be "off the plan" due to budget issues, but it may still happen and at least I know it will fit.



My Ricks tank...thank you Hector.....




Off with the old quarter panel.....


More stellar work by Chris.... this is the outer wheel tub to quarter flange than Chris did....part of the old flange and some new Chris made....nice work once again.... no wondet the panel wapred all to hell....