Welding Table

[Roadbuster]

Lots of good info here!
Mine on paper is 30 inches by 60 inches. Was planning on having holes around the frame under the top to bolt things to and a vice mounted. I was thinking of a 1/8 inch thick top shimmed level and bolted to the top but from everyone's posts that seems too thin. I was also planning on having the front open so I could roll things under it when not in use. Looks like I have to go to back to the drawing table and work on table mkII.

30 inches is the max width because I have to get through a door that is 31 inches wide.

Jon