New Vendor Sponsor--new Vintage

[marks914]

Originally Posted by 70rs

Mark, what is the total outside diameter on the gauges show above? Those are pretty cool!

It depends,
Those were 4-9/16" hole which I believe works out to about 5" OD (see installed in 67-68 below. We can build those right now, but once we open them up and reface the warranty is void. They are also expensive (retail for about $600.00 for a custom set) to purchase, reface and install. They are a good product, just if something goes wrong we do not have any recourse with the manufacturer.
We are working on a set that is basically the same but we will build here in house that is 4-3/8 mounting hole, 4-3/4 OD. They will have full stepper motor technology and be available in through the dial and perimeter lighting.
Mark