New Vendor Sponsor--new Vintage

[marks914]

Originally Posted by redfire69

I was thinking of running just the two big gauges with all six indicators like you have shown above for the datsun. I'd like something that would fit in a modified stock dash.

Sure, send we can do that, just let me know what gauges you want and we can come up with a plan.
Here are the 3-1s with the Camaro theme on them, still rough though.
Mark

[redfire69]

Originally Posted by marks914

Sure, send we can do that, just let me know what gauges you want and we can come up with a plan.
Here are the 3-1s with the Camaro theme on them, still rough though.
Mark

That's exactly what I had in mind! I'll be in touch- Ron

[70rs]

Mark, what is the total outside diameter on the gauges show above? Those are pretty cool!

[marks914]

Originally Posted by 70rs

Mark, what is the total outside diameter on the gauges show above? Those are pretty cool!

It depends,
Those were 4-9/16" hole which I believe works out to about 5" OD (see installed in 67-68 below. We can build those right now, but once we open them up and reface the warranty is void. They are also expensive (retail for about $600.00 for a custom set) to purchase, reface and install. They are a good product, just if something goes wrong we do not have any recourse with the manufacturer.
We are working on a set that is basically the same but we will build here in house that is 4-3/8 mounting hole, 4-3/4 OD. They will have full stepper motor technology and be available in through the dial and perimeter lighting.
Mark

[Bowtieracing]

Fantastic Mark!!

You have PM

[Rick Dorion]

Very nice! Is that a stock 68 housing?

[marks914]

Yes they will fit in a stock 67-68 housing and also fit 69s. We should have our version underway in about a week.
Mark

[70rs]

Originally Posted by marks914

It depends,
Those were 4-9/16" hole which I believe works out to about 5" OD (see installed in 67-68 below. We can build those right now, but once we open them up and reface the warranty is void. They are also expensive (retail for about $600.00 for a custom set) to purchase, reface and install. They are a good product, just if something goes wrong we do not have any recourse with the manufacturer.
We are working on a set that is basically the same but we will build here in house that is 4-3/8 mounting hole, 4-3/4 OD. They will have full stepper motor technology and be available in through the dial and perimeter lighting.
Mark

Great information Mark. Thanks! I like all of the options that are now available.

[68400BIRD]

I'm assuming these are all electric hook up and not mechanical?
Do they come with sensors or can you use your stock ones?
How about the speedo?
Are these hook up friendly with AAW kits?
I would also be interested in something fitting into the stock location on my 68 Firebird.

[marks914]

Originally Posted by 68400BIRD

I'm assuming these are all electric hook up and not mechanical?
Do they come with sensors or can you use your stock ones?
How about the speedo?
Are these hook up friendly with AAW kits?
I would also be interested in something fitting into the stock location on my 68 Firebird.

Yes, all of our gauges are electronic we do have mechanical speedos for those who want them)
Our speedometers are fully programmable and work with all speedo senders, OEM or aftermarket. All of our kits include all the senders (pressure, temp, and some also include fuel level sender and GM speedometer sender). You get a complete, ready to install kit. The 3-1 gauges will fit just like the Camaro.
Just let us know what you need and we will see what it takes to make it happen
Mark