Factory traction bar on 69' camaro

[ItDoRun]

Yep, that's a factory '67 12 bolt. Don't cut that bracket off! I have one that the bracket was cut off and talk about kill the value of it (even with the documented codes). I even removed the paint and showed where the old bracket welds were. People want to be stubborn about it, so I plan to buy the bracket, weld it on, and jack the price up next time I plan to sell it.

It's worth $1500 all day long (maybe more).

[Bow Tie 67]

Yep resto guys will gizz all over that rear.

It is a 67, those are indeed single leaf pads. Great rear to unload and get yourself a new Moser.

[pavell]

yea I've done some research on it; and its worth around 1500ish at the most. Unfortunately I dont have the extra cash to fork out for the moser 12 bolt; which would be $2100ish at the least for a 30-spline eaton posi.

I'm still contemplating just hacking it off; screw the purists. or may just hold off on the rear bar and install it when I have the extra cash to fork out for moser 12 bolt as well.

Thanks for the help guys!!! I apreciate it.

[Bow Tie 67]

You could get a new Moser Ford 9" housing / 31 spline axles and buy a used third member to keep costs down.

[pavell]

yea I may keep my eye out for a used rear-end; although i cant justify ripping this 12 bolt out because the previous owner went through it and installed all new stuff. it works perfect and should last a while. And dropping the rear is a pain.

[ProdigyCustoms]

$1500? I think not. That is the perfect rear for a 67 SS 396 or SS350. The May date is a little limited as they only built 67s to the 2nd week of July, but someone, somewhere will want it.

I suggest you post it on Camaros.net and E bay, $2200 and then call me for your new Moser!

[pavell]

Yea I'm still thinking about it.

But that new moser 12 bolt is definitely tempting.....haha