1st gen bolt in roll bar - five point harness

[69MyWay]

hey guys...if my goal is to have a solid secured 5 point harness and roll over protection - while not attempting to pass tech for NHRA... Right now the car has lap belts. My wife has input in the process and has her foot down on any sort of "cage" that makes enter/exit and back seat use a problem.


What do you think about getting one of these in a FOUR point version and the bolt in plates.

http://www.jegs.com/instructions/555/rollcage.pdf


I could cut to fit - tack weld - then take to a pro...but build this so that the shoulder bar slides up and down kind of like the ride tech - but not so intrusive or expensive.

Thoughts?