D&D Performance / T56 tail seal

[canrc]

I should have Ryan but he didn't eve give me a chance to do that!

On a good note Jim from Hurst called me and gave me the new seal part number and Tremec is sending me a Viper seal which is the upgrade.

[67ragtp]

Originally Posted by canrc

I should have Ryan but he didn't eve give me a chance to do that!

On a good note Jim from Hurst called me and gave me the new seal part number and Tremec is sending me a Viper seal which is the upgrade.

Raj- Could you post the part number for the metal seal when you get a chance, mine is a leaker also only 700 miles, I checked my vent tube and drive shaft yoke all looks good. Guess is poor design seal.

Thanks Rich

[chr2002ca]

Called Tremec this morning and spoked to Dale and asked him about this issue and if he had the part number for the metal-rimmed version of the seal. He said the following:

"We've heard about this issue with the rear seal and we believe it can be caused by the seal simply not be installed into the tail housing far enough from the factory or that your drivetrain/shaft is too long and it's smacking the seal during suspension travel. Check your seal and see if it seems like it's installed properly. Also, I'll check that part number for you on the metal-rimmed seal and call you back."

He did call me back 15 minutes later and gave me the following part number: 1300-044-017

Raj, is that the same part number you got from them?

[JON Q]

Mark Stielow uses D&D for all his transmission builds....

[NvrDun71]

I have used D&D in the past with good success. Not making light of your situation, but you may have just caught ol' buddy on a bad day.

[chr2002ca]

Raj, were you able to find that part number at work that you ordered from Rob at Tremec? Just wanted to compare what they told me just in case 2 different persons at Tremec have different advice on part numbers. I hate ordering the wrong part and losing time/money.

[canrc]

Originally Posted by SIXX

Mark Stielow uses D&D for all his transmission builds....

Originally Posted by NvrDun71

I have used D&D in the past with good success. Not making light of your situation, but you may have just caught ol' buddy on a bad day.

Their site says they are the largest 5/6 speed dealers, I am sure they have allot of people that purchase from them and I may have just caught someone on a bad day. That being said his comment of we sell transmissions and not tail seals is what annoyed me since they clearly have a parts section on their site but it is what it is and I did end up getting the help I needed from where I got the t56.

Originally Posted by chr2002ca

Raj, were you able to find that part number at work that you ordered from Rob at Tremec? Just wanted to compare what they told me just in case 2 different persons at Tremec have different advice on part numbers. I hate ordering the wrong part and losing time/money.

Sorry for not getting back to you earlier Chris but the part number is the same as you listed above.