Mast or Holley Retro Oil Pan (LS3 in 68 Camaro)

[68LS1]

Originally Posted by toddoky

The front end height of the Holley pan is not well suited for use in a 1st-gen/Nova LS swap unless you are willing to notch the engine crossmember for clearance. Folks have installed them by using various combinations of spacers and/or washers between the subframe and the engine stands, but it is to the detriment of your U-joint working angles to do so. With all that said, a new Holley pan has been designed specifically to address the unique requirements of this swap and was done so in combination with the new Hooker 1st-gen F-body/3rd-gen Nova LS swap engine mount brackets, transmission crossmembers, headers and exhaust systems that will soon be released.

Thanks, do you know when this revised pan is to be released?

[71RS/SS396]

You don't have to run a remote filter with that pan but if you want a cast pan then it doesn't really matter.

[CarlC]

I can't speak for the others but the ATS pan on the Camaro has been great, but a remote filter is needed. It's one of the few parts on the car that required no modifications to work properly.

[68LS1]

Originally Posted by toddoky

I work on the exhaust side of development here at Holley and haven't heard where things are at in regards to the release of the pan. The design process is done and I have seen fully machined pre-production examples around, which means manufacturing engineers are involved at this point to work out the production side of the process. I'm sure some sort of release date will soon be announced, which may even happen at the SEMA show next week where the pan will be on display.


Todd

Thanks, I'll stay tuned. Not planning update till after our summer.