Ford 9" Housing

[MillerBuilt]

Mild Steel, Mig welded fabricated housing.

Extra Strong, Extra Light, and designed to minimize gear oil slosh and keep the gear oil where it belongs. Cleaning out the garage and need gone.


$500 plus shipping (located in Mesa, AZ)

*same rear housing that resides in JCG's "2nd Test Car" (see below)


[IMG][/IMG]

[Rick D]

How wide is it and what size axle tubes??

[MillerBuilt]

Originally Posted by Rick D

How wide is it and what size axle tubes??

Rick, I will post exact width this evening when I get home to measure, but it is un-cut/full length and will accommodate the widest of car applications. Axle tubes are 3". Thanks, Jay

[carbuff]

While you are measuring, could you take a second dimension for me? Specifically how far is it from the furtherest rearward face of the center section to the back of the axle tube? My application is really tight there due to the Watts link mount, so that would be a critical dimension...

[MillerBuilt]

Originally Posted by carbuff

While you are measuring, could you take a second dimension for me? Specifically how far is it from the furtherest rearward face of the center section to the back of the axle tube? My application is really tight there due to the Watts link mount, so that would be a critical dimension...

Not a problem. Will let you know this evening. Jay

[MillerBuilt]

Originally Posted by JSM

Rick, I will post exact width this evening when I get home to measure, but it is un-cut/full length and will accommodate the widest of car applications. Axle tubes are 3". Thanks, Jay

Housing is approx. 53" end to end. So basically once housing end of choice (ie. torino end) are welded on, then brake package,,,, this un-cut housing would finish out with an approx. 61" WMS to WMS which is wider than any application I am aware of around here. Thanks, Jay

[MillerBuilt]

Originally Posted by carbuff

While you are measuring, could you take a second dimension for me? Specifically how far is it from the furtherest rearward face of the center section to the back of the axle tube? My application is really tight there due to the Watts link mount, so that would be a critical dimension...

Putting a straight edge along the back and butting the rear side of the axle tube measures approx. 4" Thanks, Jay

[MillerBuilt]

To The Top...

[MillerBuilt]

To The Top...

[MillerBuilt]

To the top....