67 Camaro "The Victim" - Lateral-g Forums

**CraigMorrison** · #1 07-24-2014, 07:26 AM

Those valve covers look good. You went with a wrinkle finish on the sub? If you use a bed liner for the undercoating, it's going to tie in real nice. We can discuss further over cocktails this weekend.

**tubbed69** · #2 07-24-2014, 09:11 AM

Slow down Curtis you just started and you are going to beat us all on the road,That's a lot of nice parts,should be a super nice ride

**Spiffav8** · #3 07-24-2014, 09:24 AM

Quote:

Originally Posted by CraigMorrison

Those valve covers look good. You went with a wrinkle finish on the sub? If you use a bed liner for the undercoating, it's going to tie in real nice. We can discuss further over cocktails this weekend.

Hope the bar is stocked! Going to be a good weekend.

Quote:

Originally Posted by tubbed69

Slow down Curtis you just started and you are going to beat us all on the road,That's a lot of nice parts,should be a super nice ride

NO!

But because you asked.....I chose a T-56 for the build as it keeps the over all costs down. That and I really don't need anything bigger at the moment. Shipped it to DG Customz where it was rebuilt and upgraded. I gotta say...staying on budget isn't easy!!!

**Spiffav8** · #4 07-24-2014, 09:50 AM

Picked up a set Wilwoods AERO6 calipers with the Nickle finish and 14" rotors for them to grab. Had to laugh a bit when these arrived as they are almost as big as the wheel that came off the car.

Jay Hilliard · #5 07-24-2014, 09:54 AM

Valve covers look great with wrinkle finish. You are updating quicker than I can post. Christmas in July for Curtis!

HBRod · #6 07-24-2014, 10:30 AM

I agree, those valve covers look awesome. Nice dress-up for not much $$$. What are you doing for the rear brakes, or were they included with the front brakes shown in the picture?

Quick progress given you are staying focused and on budget.

Rod

**Spiffav8** · #7 07-24-2014, 10:38 AM

Quote:

Originally Posted by Jay Hilliard

Valve covers look great with wrinkle finish. You are updating quicker than I can post. Christmas in July for Curtis!

Thanks. Simple and they kinda match the intake. Christmas in July for sure!! To bad I had to pay for all my presents though.

Quote:

Originally Posted by HBRod

I agree, those valve covers look awesome. Nice dress-up for not much $$$. What are you doing for the rear brakes, or were they included with the front brakes shown in the picture?

Quick progress given you are staying focused and on budget.

Rod

Rod...the rears are 4P's that match. I was lazy and didn't want to unpack those. I'll post more of the brake setup later.