J-ROD '68 Camaro

[DBasher]

Looking forward to seeing the details on the IRS install and how "simple" this build stays.....I can see the snowball forming already!

Nice Buick.


Dan

[Sieg]

Old school 427 tripower with IRS - I like it!

[Al Moreno]

Originally Posted by Sieg

Old school 427 tripower with IRS - I like it!

Me too!

[J-Rod&Custom]

Heres the morrison Rail that welds into the car.

We started getting the rear rail mocked up where they want it to go... It really requires minimal cutting to get it installed. But... we are after a lower ride height... We decided to raise the rear floor and rear rail up 2". That would give a a 5 3/4" ride height.



The rail is in, at its final height.

[Spiffav8]

Will the 2" mod allow the IRS full travel or are you going to have to make further modifications?

[Ron in SoCal]

Just so I understand, 5 3/4 measured from what point?

Great work btw

[J-Rod&Custom]

Originally Posted by Ron in SoCal

Just so I understand, 5 3/4 measured from what point?

Great work btw

Thats from the rear pinch weld (in front of wheel) to the ground.

[J-Rod&Custom]

Originally Posted by Spiffav8

Will the 2" mod allow the IRS full travel or are you going to have to make further modifications?

It will be close, we may need to modify the outer wheel well. The factory outer well almost immediately starts curving in... making it hard to tuck any tire.