Frank,those Al Knoch panels are really nice and fit fairly well.
yes they are damm good looking, just left my mind some where else when I was working on them. they could use a bit of massaging so i'll slightly bend the two upper window guides that the panel clips on to. to lower panel a bit . and will also bend sheet metal on panel where it mounts on to them like the originals.. the perimeter retainers are way off and holes are kind of chewed up but they are overall very good where it counts.
Just got around to installing weather stripping , panels fit and look great. No need to bend brackets turns out to be my repop door outer top edge was off on front end by 3/4" ( not much !!!! ) no fun on trying to keep that top edge on check as it curves twice while trying to keep top flat and even. This is one of the reasons why it will get completely built before any paint.
Just got around to installing weather stripping , panels fit and look great. No need to bend brackets turns out to be my repop door outer top edge was off on front end by 3/4" ( not much !!!! ) no fun on trying to keep that top edge on check as it curves twice while trying to keep top flat and even. This is one of the reasons why it will get completely built before any paint.
Frank I also ripped my right door from end to end,a mile off when started with the aftermarket door.
Just keep massaging it, Sometimes they can be a bitch to get a good fit, Those are one of the better brands to work with. We have to mess around with them when we have installed for customers
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
!!!! ) no fun on trying to keep that top edge on check as it curves twice while trying to keep top flat and even. This is one of the reasons why it will get completely built before any paint. 
Hybrid Mode
