WTB or trade for some Big Block Chevy parts...

[69MyWay]

Originally Posted by Vega$69

I have a nice set of Stainless Works BBC headers. Polished. Used in very good condition.

I also have a fresh 4 bolt main short block less cam. 427 6233 Crank pink rods new forged Pistons

Was gonna do a Yenko close and went LS instead. Lol

I'm hoping my block is good - you don't happen to have an HEI distributor laying around for that do you?

[Panteracer]

Will check if rockers have any parts numbers
Motor was a build in a Popular Hot Rodding article
It may have some info. Builder is long gone

Bob

[badbu68]

I've got an hei with an accel cap/coil and some 8.8 wires, can't remember what they are off top of my head. Also, I'm 30min north of you in Normal. Got a 454 short block, few sets of heads, etc. I might be willing to get rid of.

[Panteracer]

Ok yella terra rockers are 1.7 one valve and
1.75 on the other. Each pair has a number on
the 1.75 side. I have 2,3,4,5,8 and one without
a number that I believe is #1 because I know
#7 is where I had a problem

Pic attached

Might have to get one more tie bar as it looks
Like one is ground by the original bs
Builder

[Panteracer]

Sorry... my phone would not post the
picture last night

Tried again for the Rockers

Bob

[Ummgawa]

I have a bell housing that allows you to mount a T-56 to a big or small block. Never used, in new condition.

I also have a set of L-88 aluminum heads, needs some repair, but a good aluminum welder can repair them.

[XLexusTech]

I have an msd pro billet distributor if you are interested

[69MyWay]

Originally Posted by badbu68

I've got an hei with an accel cap/coil and some 8.8 wires, can't remember what they are off top of my head. Also, I'm 30min north of you in Normal. Got a 454 short block, few sets of heads, etc. I might be willing to get rid of.

I'll drop you a pm

[69MyWay]

Originally Posted by Ummgawa

I have a bell housing that allows you to mount a T-56 to a big or small block. Never used, in new condition.

I also have a set of L-88 aluminum heads, needs some repair, but a good aluminum welder can repair them.

I have the stock LT1 bellhousing that is my understanding I can bolt to the Mark IV BB and use the conversion flywheel - then keep all the other LT1 stuff...

I'm curious about what you have here...and also the heads.

[69MyWay]

Originally Posted by Panteracer

Ok yella terra rockers are 1.7 one valve and
1.75 on the other. Each pair has a number on
the 1.75 side. I have 2,3,4,5,8 and one without
a number that I believe is #1 because I know
#7 is where I had a problem

Pic attached

Might have to get one more tie bar as it looks
Like one is ground by the original bs
Builder

Okay...I'm sorry but I missed the updates to this thread and am late getting back. Thanks to the fellows that we have deals working now...going to keep the UPS guy busy.

I'll do some more checking on these for her application then let you know.