'69 Camaro Temper

[CamaroAJ]

Originally Posted by MtotheIKEo

Do you mind sharing what tools/abrasives you are using for cleaning up all of those welds? You're stuff looks fantastic. Especially all of those inside corners like the window frame.

Car is looking great. This is a fun project to watch.

Thank you.

On the large flat areas I'm using 60 grit flap disk on a 4" air grinder to get it close as it takes off a lot of metal fast. The tight corners I'm using a carbide burr bit in a straight die grinder then a sandpaper roll on a angle die grinder. The straight inside angle parts I'm just using a 3" cut off wheel to rough grind everything. To smooth the rough grinds down I'm using 36 grit down to 60 grit 3" roloc disks on a 2" arbor to get the disk to flex enough to get the corners smooth. Once everything is good to go I finish it all off with 80 grit on a DA.