Made some more progress on the rear bumper. Ended up rebuilding the sides again, just trying to get the shape right and symmetrical. Templates and a laser have it pretty darn close! I'm in the middle of the lower radius'd part. Made a wood jig to shape the lower corner. I will finish it all by the weekend.
Pretty good progress this weekend, passenger side is complete. Spent a fair amount of time doing some clean up of the driver side just to ensure complete symmetry.
Working out the details of the tail lights, location, mounting, etc.
Pretty light progress lately but finally mostly finished the new tail section. Very happy with how it came out. Kept the original lines for the most part, just enhances them a bit to fit with the flared fenders.
Those aren't real tail lights...just some poster board painted red so I could make sure the placement looks right before drilling the holes. This is basically the stock location...basically.
[ATTACH][/ATTACH]
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Hybrid Mode
