Old school air intake

[slimjim]

Originally Posted by sd67

I really tried to find that too as I want to run the old school look with my LSX 454, I have been kicking around this:

http://www.delmospeed.com/product/th...y-adapter-ls3/
http://www.jegs.com/i/Chevrolet-Perf...44033/10002/-1

The height is a challenge, probably 11 inches from the deck of the motor, which I am not sure will fit even with the 2 inch cowl hood.

If you find someone that will do the custom version with the stock intake like the photo, then count me in for one too.

Is that to adapt your current throttle body?
I just looked, there's a lot less options for the LS7 unfortuneately, I think the height of the setup you're suggesting will be around 9" for an LS3. If I go this route I'll be using this.
https://www.holley.com/products/fuel.../parts/112-587

But I must admit I havent done my full homework yet.... or built the LS3