2nd Chance Camaro - Let the Project Begin

[syborg tt]

I had time to do a couple simple projects so out to the garage I went.







I decided to mock up some of the hoses.



Thankfully the auto parts store is close



Nope, I don't like the way this hose looks.





I ordered this custom hose with all kinds of crazy bends in it.

[camcojb]

Originally Posted by syborg tt

I ordered this custom hose with all kinds of crazy bends in it.

Yep, I've made good use of those molded smaller hoses for certain vacuum lines, turn out much cleaner looking.

[syborg tt]

Way back somewhere in this thread I installed Painless fan relay and I screwed up and didn't order a standard fan relay. So I ordered a new Water Proof Fan Relay kit.



Since it is in between the battery and the radiator the batter once again needs to come out.









Thankfully I used a weather pack connector as I was able to just remove the ground from the plug.

[syborg tt]

My molded hose arrived







I also received another fitting for the Fuel Pressure Sensor



Looks like I need a longer hose.



Found an all in one fitting that will be replacing two of the fittings.

[syborg tt]

Since I keep the car on the optima charger when it is parked in the garage I decided to mock up the wire and see if I could hide it when it's not in use.





I can easily tuck it in the frame rail when not in use.

[syborg tt]

Today I will be working on all of the various ground wires.

My goal is to make then looks nice and I even have some company in the garage today.







Ground wire from the block to the frame





Wires running back to the battery ( I think I have a cool idea and I hope to share it soon )







Securing the ground wire to the motor mount bolt.





I am finally connecting the wires from the relay to my gas tank.















I also purchased this bad ass headlight switch from a gentleman on Facebook. I am going to have it anodized
black so it blends in with the Covan dash insert.



I have been looking for Intake Tube idea's and I think I found one that I love.

[syborg tt]

Another reminder while I am here to powder coat the spring pocket and the lower arms.



The fuel lines runs right over the spring pocket and I am going to trim a little bit of it off to protect the fuel line.



I started slowly removing just a little bit.



Then I took just a little more off.



Out comes them death wheel.





A little clean up.



All better now and I am still going to run the line through DEI ExoSleeve.

[syborg tt]

I am finally installing the FlexKore brake lines.



Old lines are coming out.