67 Camaro project "It Don't Fit"

[Sonar Chief]

Originally Posted by makoshark

FINALLY got the driver's side mini tub installed!!!!!!!

Nice Are you gonna stitch weld the inside to the trunk and pan?
Looks good, keep it up and you'll be done

[makoshark]

Originally Posted by Sonar Chief

Nice Are you gonna stitch weld the inside to the trunk and pan?
Looks good, keep it up and you'll be done

Yeah, I have a bit of a gap where I cut out too much metal at the rear of the tub. I'll finish welding it all there once I get it up on the rotisserie. It's just plug welded at the moment. Just like the factory did it

[makoshark]

I take that back, I forgot. I have to fill in a gap at the rear of the tub in the trunk and I'm going to use some Lord Fusor body adhesive instead of stitch welding it there.

[makoshark]

Driveline angles! Any help?

[Sieg]

Originally Posted by makoshark

Driveline angles! Any help?

Here ya go:
http://www.iedls.com/Education-Zone.asp?CID=6

http://www.hurst-drivelines.com/wp-c...roc_111606.pdf

[makoshark]

Thanks Sieg

[makoshark]

I got the passenger side tub cut out and prefitted. I'm pleased with how well it's fitting with just my first cut. There is not going to hardly be any trimming to this side to make fit well.

I have to finish notching the frame rail at the bottom. Make the closeouts and the reinforcement bracket that I made to go inside the frame rails. I also have to epoxy prime the tub and drill holes in it. I wonder if I can accomplish all this tomorrow