Roadster Shop 2nd Gen Camaro Build

[preston]

I've always been extremely careful spec'ing out internal fuel tank hose, using only the hose specifically SAE rated for fuel immersion, and was under the impression that none of the retail style aeroquip/earl's etc. braided or otherwise hose was appropriate. That just looks like standard push on hose like you can buy at Summit or wherever. Can you tell us what brand/spec blue hose that is ?

Nice job laying out the fuel sump and pickups and stuff, but of course I assume RS would be top notch.

[INTMD8]

Originally Posted by RS-Chris

Pic time!

Fabbing the dual fuel tanks and install:
(35.5 Gal total - 24.4 Pump gas and 11.1 for the good stuff)

Staged injection? Looks very nice!

[RS-Chris]

Originally Posted by preston

I've always been extremely careful spec'ing out internal fuel tank hose, using only the hose specifically SAE rated for fuel immersion, and was under the impression that none of the retail style aeroquip/earl's etc. braided or otherwise hose was appropriate. That just looks like standard push on hose like you can buy at Summit or wherever. Can you tell us what brand/spec blue hose that is ?

Nice job laying out the fuel sump and pickups and stuff, but of course I assume RS would be top notch.

Thanks.

It is Aeroquip hose, rated for immersion. Same stuff Fuel Safe uses.

[Torq'd Design Lab]

I enjoyed looking at this project when I was up there last month!! Its looking good!!

[67XR7]

Awesome work once again!!!

[broken1234]

Any updates?

[waynieZ]

That fuel cell is awesome.

[GregWeld]

Originally Posted by RS-Chris

I'd have built the fans to drop out the bottom so they could be serviced easily if they needed to be.

[Roadster Shop]

Originally Posted by GregWeld

I'd have built the fans to drop out the bottom so they could be serviced easily if they needed to be.

When you start lowering your consulting fees maybe we will start using you!

Either way it is a few bolts and the fan comes right out.

[Roadster Shop]

Originally Posted by broken1234

Any updates?

We will throw a few more pics up tomorrow. Been doing a lot of the little detail work in the engine compartment, fabbing the exhaust, and finishing up all of the loose ends before going to body work.