Another little Falcon

[rjardy]

Originally Posted by DBasher

10-1/2" C-C compressed
14-1/2" C-C extended

The second picture is one of the fronts, looks the same to me other then the top mount which can be changed.

No pictures at the moment. It is the TCI 4 link for the Falcons. Those look like they'll work great. Let me take some measurements.

[rjardy]

12.5 center to center at ride height. Those should work great.

[DBasher]

I'll send you a PM, you want the fronts as well? Haha!

[jarhead]

Nice work Rob!

[rjardy]

Originally Posted by jarhead

Nice work Rob!

Thanks, Jarhead!

Should have some finished pictures here in a couple hours. I have in-laws in town so I only get a few minutes at a time haha


Rob

[rjardy]

I screwed up the right side panel. While drilling one of the holes, I let the check touch the panel. Didnt notice it until it was to late. I may make another right side panel. Or I may not... This is a driver after all. I used 3M strip caulk everywhere the panels touched the grill or the core support. No rattles. My car probably have 5lbs of this stuff on it.


-Rob

[rustomatic]

Cool panel--that really cleans things up! Next thing you know, you'll be figuring out how to put an Audi V10 in the back of that thing. Beware the slippery slope . . .

. . . because people with Falcons must always keep the hands busy.

You asked about pictures of mine (when it worked). I think Sieg took the best ones (former dents included) at Sonoma Raceway last year--they're floating around the site somewhere. Dan (DBasher) took some cool ones at Thunderhill earlier this year (see his thread in the Race Car section--it became a Falcon mashup). It's a good thing, because I suck with the picture-taking.